|
Q.
How hot is the water from the Takagi tankless water
heater?
A.
The
Takagi tankless water heater has a computer-controlled
system, which will provide a preset output temperature of
140ºF for the T-M1 & 120ºF for all other
models. You can set 4 different temperatures w/ the
dipswitches for certain models. With the remote control,
you can choose a wider temperature range.
Q.
How much hot water I can have?
A.
The
Takagi tankless water heater output temperature is set by
the factory to either 120 or 140ºF. Depending on the
model, the maximum output flow rate is as high as 9.6
gallons per minute.
Q.
What is the difference between the Takagi tankless
water heater & a typical tank type water
heater?
A.
With
a tank type water heater, you can draw hot water as fast
as your plumbing will allow, however when the hot water
tank is depleted, you have to wait for the tank to
re-heat before you can use hot water again. Takagi
tankless water heaters eliminate the pilot light w/ a
computer-controlled electronic ignition. w/
computer-modulated gas valves, water is heated once,
rapidly, efficiently & only as needed.
Q.
Can I use more than two fixtures at the same
time?
A.
Yes.
The Takagi tankless water heater will can handle more
than two fixtures, such as showers at the same
time.
Q.
Has the Takagi tankless water heater been approved by
Government or National Standards?
A.
Yes.
The all of the Takagi tankless water heaters are approved
by the CSA & are listed by the Trade Commission &
California Energy Commission w/ over 80% thermal
efficient.
Q.
How can the tankless water heater save
money?
A.
Most
tank type water heaters raise their heat about 3 to 4%
each hour. Since the Takagi tankless water heater heats
water only when the faucet is turned on, there is no
standby heat loss. It only uses energy when you are using
hot water & it only heats as much water as is
needed.
Q.
Does the Takagi tankless water heater have a pilot
light?
A.
No.
The Takagi tankless water heater has an electronic
ignition system. This means no more wasted gas &
money.
Q.
Does the Takagi tankless water heater require
electrical power to operate?
A.
Yes.
The Takagi tankless water heater has a fan, a computer
board & electronic ignition. You need 110V but it
only takes a maximum 0.8A draw.
Q.
What kind venting system does it have?
A.
The
Takagi tankless water heater has a power venting system
w/ fan assistance. The vent size is a 4" standard round
vent; it can run out the roof or sidewall. If it is
installed outdoors, it doesn't need any vent.
Q.
What size are the water & gas
connections?
A.
The
Takagi tankless water heater inlet & hot water outlet
are connected w/ standard 3/4" water connections. Gas
connection is 3/4" & the gas supply piping required
is 3/4".
|